User guide

Chapter 5. Command Line Interface Reference 181

ETH LIST

Lists information about the Ethernet interfaces including the status of bridging and routing, IP protocol controls,

and IP address and subnet mask.

interface Ethernet interface for which information is listed. If the parameter is omitted, information is

listed for all Ethernet interfaces in the router.

For a dual-port router, you may specify the port number (0 or 1).

If logical interfaces are defined, you may specify a port and logical interface number

(<port #>:<logical interface #>, such as 0:1).

Example:

# eth list

GLOBAL BRIDGING/ROUTING SETTINGS:

Bridging enabled..................... no

Exchange spanning tree with dest... yes

IP Routing enabled................... yes

Multicast forwarding enabled....... no

Firewall filter enabled............ yes

Directed Broadcasts Allowed........ no

RIP Multicast address.............. default

IPX Routing enabled.................. no

ETHERNET INFORMATION FOR <ETHERNET/0>

Hardware MAC address................. 00:20:6F:02:98:04

Send IP RIP to the LAN................. no

Advertise me as default router..... yes

Process IP RIP packets received...... no

Receive default route by RIP....... yes

IP filters defined................... no

IP address/subnet mask............... 192.168.0.101/255.255.255.0

Static Ethernet routes defined....... 1

IP address/subnet mask............. 0.0.0.0/0.0.0.0

IP gateway/metric.................. 192.168.0.252/1

Virtual Ethernet routes defined...... none

IPX External network number.......... 00000000

IPX Frame type....................... 802.2

MTU.................................. default

eth list [<interface>]