User guide

180 Chapter 5. Command Line Interface Reference
ETH IPX DISABLE
Disables IPX routing across the Ethernet LAN. This acts as a master switch allowing you to disable IPX Routing
for testing or control purposes.
Note: This command requires a reboot.
ETH IPX ENABLE
Enables IPX routing across the Ethernet LAN. This acts as a master switch that allows you to enable IPX routing.
Note: This command requires a reboot.
ETH IPX FRAME
Sets the frame encapsulation method. The default is 802.2.
ipxnet IPX network number represented by 8 hexadecimal characters.
port# Port number of the Ethernet LAN. This number must be 0 or 1, or it may be omitted.
Example:
eth ipx addr 123
eth ipx disable [port#]
port# Port number of the Ethernet LAN. This number must be 0 or 1, or it may be omitted.
Example:
eth ipx disable
eth ipx enable [port#]
port# Port number of the Ethernet LAN. This number must be 0 or 1, or it may be omitted.
Example:
eth ipx enable
eth ipx frame <type>
type 802.2 (DEC standard)
802.3 (Intel standard)
dix (Xerox/Ethernet II standard)
Example:
eth ipx frame 802.3