Specifications

58 Chapter 3. Configuring Router Software
Configuring a Dual-Ethernet Router for IP Routing
This table outlines commands used to configure a Dual-Ethernet router for IP routing.
Dual-Ethernet Router with IP Routing
Steps Settings Commands
System Settings
System Name Optional system name <name>
System Settings
Message Optional system msg <message>
Ethernet Settings
Routing/ Bridging
Controls
Enable IP routing
Disable bridging
eth ip enable
eth br disable
ETH/0 IP Address DeÞne ETH/0 IP address for
the hub side
eth ip addr <ipaddr> <ipnetmask> [<port#>]
ETH/1 IP Address DeÞne ETH/1 IP address for
the single 10Base-T side
eth ip addr <ipaddr> <ipnetmask> [<port#>]
TCP/IP default route
address
ETH/0 sends all trafÞc to
ETH/1
eth ip addroute <ipaddr> <ipnetmask> <gateway>
<hops> [<port#>]
DHCP Settings
Already enabled; additional settings may be required
DHCP Settings DeÞne DHCP network for
ETH/1
dhcp add | <net> <mask> | <ipaddr> | <code>
<min> <max> <type>
Create an address pool for
ETH/1
dhcp set addresses <Þrst ipaddr> <last ipaddr>
DNS Domain Name dhcp set valueoption domainname <domainname>
DNS Server dhcp set valueoption domainnameserver <ipaddr>
WINS Server Address dhcp set valueoption winsserver <ipaddr>