Specifications

56 Chapter 3. Configuring Router Software
Configuring FRF8 with IP Routing
This table outlines configuration commands for the FRF8 Link Protocol with the IP Routing Network Protocol.
FRF8 with IP Routing
Steps Settings Commands
System Settings
System Message Optional system msg <message>
Ethernet IP Address As required eth ip addr <ipaddr> <ipnetmask> [<port#>]
DHCP Settings Already enabled;
additional settings may
be required
dhcp set valueoption domainname <domainname>
dhcp set valueoption domainnameserver <ipaddr>
Change Login Optional system admin <password>
Remote Routers
New Entry Enter: Remote Name remote add <remoteName>
Link Protocol/PVC Select: FRF8
Enter: VPI/VCI Numbers
remote setProtocol FRF8 <remoteName>
remote setPVC <vpi number>*<vci number>
<remoteName>
Bridging On/Off Must be off remote disBridge <remoteName>
TCP/IP Route Address Enter: explicit or default
route
remote addIproute <ipnet> <ipnetmask> <hops>
<remoteName>
If Address Translation
(NAT) is enabled:
To enable NAT, use: remote setIpTranslate on <remoteName>
If NAT is OFF: Enter: Source WAN Port
Address + mask of the
remote network
remote setSrcIpAddr <ipaddr> <mask><remoteName>
TCP/IP Route
Addresses
Enter a Source WAN Port
Address + mask of the
remote network
remote setSrcIpAddr <ipaddr> <mask><remoteName>
IP and IPX Routing
TCP/IP Routing
(Internet Firewall)
Must be enabled
(Optional)
eth ip enable
eth ip Þrewall <on | off >
IPX Routing Must be disabled eth ipx disable
Store
Reboot
save
reboot