Specifications

Chapter 3. Configuring Router Software 55
Configuring MAC Encapsulated Routing: RFC 1483MER / RFC
1490MER with IP Routing
This table outlines configuration commands for the RFC 1483MER and RFC 1490MER Link Protocols with the
IP Routing Network Protocol.
RFC 1483MER / RFC 1490 MER with IP Routing
Steps Settings Commands
System Settings
System Message Optional system msg <message>
Ethernet IP Address As required eth ip addr <ipnet> <ipnetmask> [<port#>]
DHCP Settings Already enabled;
additional settings may
be required
dhcp set valueoption domainname <domainname>
dhcp set valueoption domainnameserver <ipaddr>
Change Login Optional system admin <password>
Remote Routers
New Entry Enter: Remote Name remote add <remoteName>
Link Protocol/PVC
a
(for ATM routers)
a Enter this information if you are using RFC 1483 in an ATM environment.
Select: RFC 1483MER
Enter: VPI/VCI Numbers
remote setProtocol RFC1483MER <remoteName>
remote setPVC <vpi number>*<vci number>
<remoteName>
Link Protocol/DLCI
b
(for Frame Relay
routers)
b Enter this information if you are using RFC 1490 in a Frame-Relay environment.
Select: MER
Enter: DLCI number
remote setProtocol MER <remoteName>
remote setDLCI <number> <remoteName>
Bridging On/Off
Must be off remote disBridge <remoteName>
TCP/IP Route Address Enter: Explicit or default
route with remote
gateway
remote addiproute <ipnet> <ipnetmask><ipGateway>
<ipGateway> <remoteName>
If NAT is enabled: To enable NAT, use: remote setIpTranslate on <remoteName>
If NAT is OFF: Enter: Source WAN Port
Address + mask of the
remote network
remote setSrcIpAddr <ipaddr> <mask><remoteName>
TCP/IP Route
Addresses
Enter a Source WAN Port
Address + mask of the
remote networkÕs mask
remote setSrcIpAddr <ipaddr> <mask> <remoteName>
IP and IPX Routing
TCP/IP Routing
(Internet Firewall)
Must be enabled
(optional)
eth ip enable
eth ip Þrewall <on | off >
IPX Routing Must be disabled eth ipx disable
Store
Reboot
save
reboot