Specifications

54 Chapter 3. Configuring Router Software
Configuring RFC 1483 / RFC 1490 with Bridging
This table outlines configuration commands for the RFC 1483 and RFC 1490 Link Protocols with the Bridging
Network Protocol.
RFC 1483 / RFC 1490 with Bridging
Steps Settings Commands
System Settings
System Message Optional system msg <message>
DHCP Settings Already enabled;
additional settings may be
required
dhcp set valueoption domainname <domainname>
dhcp set valueoption domainnameserver <ipaddr>
Change Login Optional system admin <password>
Remote Routers
New Entry Enter: Remote Name remote add <remoteName>
Link Protocol/PVC
(for ATM routers)
Select: RFC 1483
Enter: VPI/VCI Numbers
remote setProtocol RFC1483 <remoteName>
remote setPVC <vpi number>*<vci number>
<remoteName>
Link Protocol/DLCI
a
(for Frame Relay
routers)
a Enter this information if you are using RFC 1490 in a Frame-Relay environment.
Select: FR
Enter: DLCI number
remote setProtocol FR <remoteName>
remote setDLCI <number> <remoteName>
Bridging On/Off Must be on remote enaBridge <remoteName>
IP and IPX Routing
IP Routing Must be disabled eth ip disable
IPX Routing Must be disabled eth ipx disable
Store
Reboot
save
reboot