Specifications

364 Appendix A. Network Information Worksheets
Configuring FRF8 with IP Routing
RFC 1483FR with IP Routing
Steps Commands Your Settings
System Settings
System Message system msg <message> ...............................................
Ethernet IP Address eth ip addr <ipaddr> <ipnetmask> [<port#>] ...............................................
DHCP Settings
dhcp set valueoption domainname < domainname>
dhcp set valueoption domainnameserver <ipaddr>
...............................................
Change Login system admin <password> ...............................................
Remote Routers
New Entry remote add <remoteName> ...............................................
Link Protocol/PVC remote setProtocol FRF8 <remoteName>
remote setPVC <vpi number>*<vci number>
<remoteName>
...............................................
Bridging On/Off remote disBridge <remoteName> ...............................................
TCP/IP Route
Address
remoteaddIproute <ipnet> <ipnetmask>
<hops><remoteName>
...............................................
If NAT is enabled:
To enable NAT
-AND-
You must enter a
Source WAN Port
Addr
remote setIpTranslate on <remoteName>
remote setSrcIpAddr <ipaddr> <mask>
<remoteName>
a
a The mask is the mask of the remote network
...............................................
If NAT is not enabled:
You may need to enter
a Source WAN Port
Addr
remote setSrcIpAddr <ipaddr> <mask>
<remoteName>
b
b The mask is the mask of the remote network
...............................................
IP and IPX Routing
TCP/IP Routing
(Internet Firewall)
eth ip enable
eth ip Þrewall <on | off>
...............................................
IPX Routing eth ipx disable ...............................................
Store
Reboot
save
reboot