Specifications

Appendix A. Network Information Worksheets 363
Configuring RFC 1483MER / RFC 1490MER with IP Routing
RFC 1483MER/RFC 1490MER with IP Routing
Steps Commands Your Settings
System Settings
System Message system msg <message> ...................................................
Ethernet IP Address eth ip addr <ipaddr> <ipnetmask>[<port#>] ...................................................
DHCP Settings
dhcp set valueoption domainname < domainname>
dhcp set valueoption domainnameserver <ipaddr >
...................................................
Change Login system admin <password> ...................................................
Remote Routers
New Entry remote add <remoteName> ...................................................
Link Protocol/PVC
a
(for ATM routers)
a Enter this information if you are using RFC 1483 in an ATM environment.
remote setProtocol RFC1483MER
<remoteName>
remote setPVC <vpi number>*<vci number>
<
remoteName>
...................................................
Link Protocol /DLCI
b
(for Frame Relay
Routers)
b Enter this information if you are using RFC 1490 in a Frame-Relay environment.
remote setProtocol MER <remoteName>
remote setDLCI <number><remoteName>
...................................................
Bridging On/Off remote disBridge < remoteName> ...................................................
TCP/IP Route
Address
remote addIproute <ipnet>
<ipnetmask><ipgateway> <hops>
<remoteName>
...................................................
If NAT is enabled:
To enable NAT,enter:
-and-
Enter a Source WAN
Port Addr
remote setIpTranslate on <remoteName>
remote setSrcIpAddr <ipaddr> <ipnetmask>
<remoteName>
c
c The mask is the mask of the remote network.
...................................................
If NAT is not enabled:
You may need to enter
a Source WAN Port
Addr
remote setSrcIpAddr <ipaddr> <ipnetmask>
<remoteName>
d
d The mask is the mask of the remote network.
...................................................
IP and IPX Routing
TCP/IP Routing
(Internet Firewall)
eth ip enable
eth ip Þrewall <on | off>
...................................................
IPX Routing eth ipx disable ...................................................
Store
Reboot
save
reboot