Specifications

3
WhatÕs New in This Release?
This version of the Command Line Interface (CLI) manual has been updated to document features available with
this release of the kernel software. The following list directs you to the CLI documentation for these new features:
Release 5.0:
VRRP Backup Ñ page 107
¥ Implements the Virtual Router Redundancy Protocol (RFC 2338).
¥ Allows other routers in the LAN to serve as backups for a static default gateway.
Dial Backup Ñ see page 103
¥ Uses a V.90 modem connected to the console port as an automatic backup when the DSL link fails.
SDSL Autobaud Pre-Activation Procedure Ñ see page 305
¥ Shortens the time required to find the correct line speed by checking the line quality before activation.
New IKE Commands
¥ Perfect Forward Secrecy option to increase the security of the IKE key exchange Ñ see page 136.
¥ Option to restrict policy use to a specific interface Ñ see page 337.
¥ Option to have network address translation performed before IPSec encryptionÑ see page 340.
Interface Stop, Start and Restart
¥ Commands to stop, start, and restart a logical Ethernet interface Ñ see page 77.
¥ Commands to stop, start, and restart an active session for a remote Ñ see page 32.
Voice router support
¥ Command to change voice profile available if voice gateway is ATM standards-based Ñ see page 21.
¥ Command to adjust jitter buffer size Ñ see page 175.
Multiple BootP relays Ñ see page 152
¥ Use dhcp addrelay and dhcp delrelay commands to change the BootP server list.
Changes to Syslog server list Ñ see page 153
¥ The command syntax has changed for system addSyslogServer and system delSyslogServer .
New Òall protocolsÓ option on AddServer commands
¥ system addServer Ñ see page 209; remote addServer Ñ see page 259; eth ip addServer Ñ see page 232.
New DHCP command Ñ see page 312
¥ Command to clear all DHCP information.