Specifications

296 Chapter 8. Command Reference
Dual-Ethernet Router (ETH) Commands
The following Ethernet commands are used to manage the Ethernet interfaces of the Dual-Ethernet (Ethernet-to-
Ethernet) router and thus are specific to that type of router only. For the other Ethernet commands, see page 229.
¥ The Dual-Ethernet router has two interfaces:
ETH/0 Hub with four 10Base-T connectors
ETH/1 Single 10Base-T connector
¥ This Dual-Ethernet router may be configured via the Web Browser GUI or from the Command Line Interface
(CLI). To set up any DHCP options and to configure optional features like IP filtering, you must use the CLI.
¥ For configuration information, refer to Dual-Ethernet Router Configuration, on page 45 and the Customer
Release Notes provided with the Dual-Ethernet router.
¥ If you use the Boot from Network option from the boot menu to perform a boot code update, the boot
request is sent from the ETH/0 interface only.
ETH BR ENABLE
Enables bridging in a Dual-Ethernet environment. This command requires rebooting the router for the change to
take effect.
ETH BR DISABLE
Disables bridging in a Dual-Ethernet environment.
Note: This command requires rebooting the router for the change to take effect.
ETH BR OPTIONS
Sets controls on bridging for the Ethernet interface To see the current bridge settings for the Ethernet interface,
use the eth list command.
Warning: Do not change the stp setting without approval from your system administrator.
eth br enable
Example:
eth br enable
eth br disable
Example:
eth br disable
eth br options <option> on | off [<port#>]