Specifications

Chapter 8. Command Reference 285
REMOTE SETPVC
Specifies the PVC number for connecting to the remote router.
REMOTE SETRMTIPADDR
Sets the WAN IP address for the remote router. This address is required only if the remote router does not support
IP address negotiation under PPP (i.e., numbered mode is required, and the remote router cannot specify a WAN
IP address for use during the negotiation process).
REMOTE SETSPEED
Specifies the speed to be used when dialing out using the backup V.90 modem connected to the console port.
Specify a speed for each phone number you provide (primary and alternative).
RFC1483 RFC 1483 protocol.
RFC1483MER RFC 1483MER (MAC Encapsulated Routing) protocol.
FRF8 This protocol implements ATM to frame relay as deÞned in the Frame Relay Forum FRF.8
Interworking Agreement.
RAWIP RawIP protocol.
remoteName Name of the remote router (character string).
Example:
remote setProtocol ppp fp1
remote setPVC <vpi number>*<vci number> <remoteName>
vpi number Virtual Path ID Ñ number that identiÞes the link formed by the virtual path.
vci number Virtual Circuit ID Ñ number that identiÞes a channel within a virtual path in a DSL/ATM
environment.
remoteName Name of the remote router (character string).
Example:
remote setPVC 0*38 HQ
remote setRmtIpAddr <ipaddr> <mask> <remoteName>
ipaddr IP address of the remote router, in the format of 4 decimals separated by periods.
mask IP network mask of the remote router, in the format of 4 decimals separated by periods.
remoteName Name of the remote router (character string).
Example:
remote setRmtIpAddr 128.1.210.65 255.255.255.192 HQ