Specifications

Chapter 6. Managing the Router 163
FLASH Memory Recovery Procedures
Recovering Kernels for Routers with Configuration Switches
In the unlikely event that the FLASH file system should become corrupted, attempt to recover using these steps.
Perform the following procedures in the order listed:
1. Try to repair the file system by issuing the msfs command. While logged in, issue a sync command followed
by an msfs command. If the display shows that the file system is corrupted, verify that no other console (via
Telnet) is currently modifying the file system with the ps command. Then attempt to repair the file system
typing the following commands:
msfs fix
sync
2. If the file system is still corrupted (i.e., you cannot write a file), you will have to reformat the file system.
First, attempt to save your configuration files as explained in the section Backup and Restore Configuration
Files, on page 162. Then, while logged in, enter the following commands:
format disk
save
copy [e-mail]:kernel.f2k kernel.f2k
sync
The above command sequence assumes that the software presently running from RAM is correctly configured
and is still functional. The save command re-creates all the configuration files (except the FILTER.DAT file,
which you may re-create manually by typing save filter). The copy command reinstalls the operational
software on the FLASH file system, and sync commits all this information to disk.
3. In the event that the software running from RAM is not sufficiently functional to perform those steps, you
will have to boot from the network using a TFTP server, as explained in the section Software Kernel
Upgrades, on page 159.
If you cannot issue the format command (as explained in the previous step), you will have to erase the
FLASH file system from the boot code.
a. Flip configuration switch 6 to the down position and reboot the router (by powering down and up again,
for example).
b. At the manual boot menu, select 5. ÒConfigure boot systemÓ, and enter the ÒmagicalÓ number 98. Then,
move switch 6 back to its up position.
c. Reboot from the network following the steps described in the Software Upgrade Procedure. You will
notice error messages indicating that the file system is not formatted. Then log in and enter:
format disk
d. Recreate the configuration files either by re-entering the information or by restoring them from a TFTP
server. Re-install the operational software by entering the command:
copy [e-mail]:kernel.f2k kernel.f2k
This assumes that TCP/IP routing is enabled and that an IP address has been assigned to the Ethernet
interface.