Specifications

14 How to Access the Command Line
Terminal Session for Macintosh or UNIX
To open a terminal window emulation in a Macintosh or UNIX environment, you need a VT100 terminal
emulation program.
1. Start your VT100 terminal emulator.
2. Configure the emulator with the following port settings:
Telnet Session for Remote Access
The router supports Telnet access. (For more information, see Telnet Remote Access, page 151.) However, remote
access to the router configuration can be disabled or restricted (see Controlling Remote Management, page 101).
To set up a Telnet session under Windows for remote access to the router:
1. Make sure that your PC and router addresses are in the same subnetwork. For example, the router address
could be 192.168.254.254 and the PC address could be 192.168.254.253.
2. Click the Start button on your PC desktop and select Run .
3. In the window, enter telnet 192.168.254.254 and select OK .
Baud rate
(Data rate): 9600
Data bits: 8
Parity: None
Stop bits: 1
Flow control: Hardware
(To use a baud rate other
than 9600, see page 157.)