Product specifications

Efficient Networks
®
Router family
Technical Reference Guide
Chapter 3: Installation and Setup
Efficient Networks
®
Page 3-51
Verify the Router Configuration
This section contains procedures to verify the router configuration testing IP, IPX and
bridging.
Test IP Routing
Test IP Routing over the Local Ethernet LAN (from PC)
• Use the TCP/IP ping command or a similar method to contact the configured
local router specifying the Ethernet LAN IP address. The LEDs on the router
should flash for each ping received.
• If you cannot contact the router, verify that the Ethernet IP address and
subnet mask are correct and check the cable connections.
• Make sure that you have saved and rebooted after setting the IP address.
• Check Network TCP/IP properties under Windows 95. If you are running
Windows 3.1, check that you have a TCP/IP driver installed.
If NAT is not en-
abled:
Enter: Source
WAN Port Address
+ mask of the re-
mote network
remote setsrcipaddr <ipaddr> <mask> <remote-
Name>
TCP/IP Route Ad-
dresses
Enter: Source
WAN Port Address
+ mask of the re-
mote network’s
mask
remote setsrcipaddr <ipaddr> <mask> <remote-
Name>
IP and IPX Routing
TCP/IP Routing
(Internet Firewall)
Must be disabled
(optional)
eth ip enable
eth ip firewall <on | off>
IPX Routing Must be disabled
eth ipx disable
Store
Reboot
save
reboot
a
Enter this information if you are using RFC 1483 in an ATM environment.
b
Enter this information if you are using RFC 1490 in a Frame Relay environment.
Table 3-8: RFC 1483MER / RFCMER 1490 with IP Routing (Cont.)
Steps Settings Commands