Product specifications

Chapter 3: Installation and Setup Efficient Networks
®
Router family
Technical Reference Guide
Page 3-50 Efficient Networks
®
Configuring RFC 1483MER / RFC 1490MER with IP Routing
This table outlines configuration commands for the RFC 1483MER and RFC
1490MER link protocols with the IP Routing network protocol.
IPX Routing Must be disabled
eth ipx disable
Store
Reboot
save
reboot
a
Enter this information if you are using RFC 1483 in an ATM environment.
b
Enter this information if you are using RFC 1490 in a Frame Relay environment.
Table 3-8: RFC 1483MER / RFCMER 1490 with IP Routing
Steps Settings Commands
System Settings
System Message Optional
system msg
<message>
Ethernet IP Address As Required
eth ip addr
<ipaddr> <ipnetmask> [<port#>]
DHCP Settings Already enabled;
additional settings
may be required
dhcp set valueoption
domainname <domain-
name>
dhcp set valueoption domainnameserver <ipad-
dr>
Change Login Optional
password
<password>
Remote Routers
New Entry Enter: Remote
Name
remote add
<remoteName>
Link Protocol/PVC
a
(for ATM routers)
Select: RFC
1483MER
Enter: VPI/VCI num-
bers
remote setprotocol
rfc1mer <remotename>
remote setpvc <vpi number>*<vci number> <re-
moteName>
Link Protocol/DLCI
b
(for Frame Relay rout-
ers)
Select: MER
Enter: DLCI number
remote setprotocol mer <remotename>
remote setdlci <number> <remoteName>
Bridging On/Off Must be off
remote disbridge
<remoteName>
If NAT is enabled: To enable NAT,
use:
remote setiptranslate on <remoteName>
Table 3-7: RFC 1483 / RFC 1490 with Bridging (Cont.)
Steps Settings Commands