Product specifications

Efficient Networks
®
Router family
Technical Reference Guide
Chapter 3: Installation and Setup
Efficient Networks
®
Page 3-49
Configuring RFC 1483 / RFC 1490 with Bridging
This table outlines configuration commands for the RFC 1483 and RFC 1490 link
protocols with the Bridging network protocol.
IPX Routing Must be enabled
eth ipx enable
Store
Reboot
save
reboot
a
Enter this information if you are using RFC 1483 in an ATM environment.
b
Enter this information if you are using RFC 1490 in a Frame Relay environment.
Table 3-7: RFC 1483 / RFC 1490 with Bridging
Steps Settings Commands
System Settings
System Message Optional
system msg
<message>
DHCP Settings Already enabled;
additional settings
may be required
dhcp set valueoption domainname <domain-
name>
dhcp set valueoption domainnameserver <ipad-
dr>
Change Login Optional
password <password>
Remote Routers
New Entry Enter: Remote
Name
remote add <remoteName>
Link Protocol/PVC
a
(for ATM routers)
Select: RFC1483
Enter: VPI/VCI
numbers
remote setprotocol rfc1483 <remotename>
remote setpvc <vpi number>*<vci number> <re-
moteName>
Link Protocol/DLCI
b
(for Frame Relay
routers)
Select: FR
Enter: DLCI num-
ber
remote setprotocol fr <remotename>
remote setdlci <number> <remoteName>
Bridging On/Off Must be on
remote enabridge <remoteName>
If NAT is not en-
abled:
You may need to
enter a Source
WAN Port Address
remote setsrcipaddr <ipaddr> <mask> <remote-
Name>
IP and IPX Routing
IP Routing Must be disabled
eth ip disable
Table 3-6: RFC 1483 / RFC 1490 with IPX Routing (Cont.)
Steps Settings Commands