Product specifications

Chapter 3: Installation and Setup Efficient Networks
®
Router family
Technical Reference Guide
Page 3-46 Efficient Networks
®
Configuring RFC 1483 / RFC 1490 with IP Routing
This table outlines configuration commands for the RFC 1483 and the RFC 1490 link
protocols with the IP Routing network protocol.
If NAT is not en-
abled:
You may need to
enter a Source
WAN Port Address
remote setsrcipaddr <ipaddr> <mask> <remote-
Name>
IP and IPX Routing
TCP/IP Routing Must be disabled
eth ip disable
IPX Routing Must be disabled
eth ipx disable
Store
Reboot
save
reboot
a
Enter this information if you are using PPP in an ATM environment.
b
Enter this information if you are using PPP in a Frame Relay environment.
c
If the ISP does not support the authentication of the ISP system by the caller, use the command
remote disauthen <remoteName> to disable the authentication.
Table 3-5: RFC 1483 / RFC 1490 with IP Routing
Steps Settings Commands
System Settings
System Message Optional
system msg
<message>
Ethernet IP Address
As Required
eth ip addr
<ipaddr> <ipnetmask> [<port#>]
DHCP Settings Already enabled;
additional settings
may be required
dhcp set valueoption domainname <domain-
name>
dhcp set valueoption domainnameserver <ipad-
dr>
Change Login Optional
password <password>
Remote Routers
New Entry Enter: Remote
Name
remote add <remoteName>
Link Protocol/PVC
a
(for ATM routers)
Select: PPP
Enter: VPI/VCI
numbers
remote setprotocol ppp <remotename>
remote setpvc <vpi number>*<vci number> <re-
moteName>
Table 3-4: PPP with Bridging (Cont.)
Steps Settings Commands