Product specifications

Efficient Networks
®
Router family
Technical Reference Guide
Chapter 3: Installation and Setup
Efficient Networks
®
Page 3-43
Configuring PPP with IPX Routing
This table outlines configuration commands for the PPP link protocol with the IPX
Routing network protocol.
If NAT is not en-
abled:
You may need to
enter a Source
WAN Port Address
remote setsrcipaddr <ipaddr> <mask> <remote-
Name>
IP and IPX Routing
TCP/IP Routing
(Internet Firewall)
Must be enabled
(optional)
eth ip enable
eth ip firewall <on | off>
IPX Routing Must be disabled
eth ipx disable
Store
Reboot
save
reboot
a
Enter this information if you are using PPP in an ATM environment.
b
Enter this information if you are using PPP in a Frame Relay environment.
c
If the ISP does not support the authentication of the ISP system by the caller, use the command
remote disauthen <remoteName> to disable the authentication.
Table 3-3: PPP with IPX Routing
Steps Settings Commands
System Settings
System Name Required
system name
<name>
System Message Optional
system msg
<message>
Authentication Pass-
word
Required
system passwd
<password>
Ethernet IP Address As Required
eth ip addr
<ipaddr> <ipnetmask> [<port#>]
DHCP Settings Already enabled;
additional settings
may be required
dhcp set valueoption
domainname <domain-
name>
dhcp set valueoption domainnameserver <ipad-
dr>
Change Login Optional
password
<password>
Ethernet IPX Network
#
Enter: IPX network #
Frame Type (de-
fault: 802.2)
eth ipx addr
<ipxnet> [<port#>]
eth ipx frame <type>
Table 3-2: PPP with IP Routing (Cont.)
Steps Settings Commands