Product specifications

Chapter 3: Installation and Setup Efficient Networks
®
Router family
Technical Reference Guide
Page 3-40 Efficient Networks
®
Configuring the Router
Having planned your configuration and acquired the necessary information as
described in Planning the Configuration, you are ready to configure your router. If you
will be configuring the system though the Web management Interface, please refer to
the User Reference Guide located on this CD. The content to follow details the
configuration via the command line interface.
This section assumes that you have:
• installed the router hardware,
• connected to the router with a terminal emulation session (or ASCII terminal),
and,
• powered the unit on.
This section contains configuration commands for each combination of link protocol
and network protocol supported by the router. (Your Network Service Provider
determines the link protocol that you use.)
For complete, individual descriptions of the commands mentioned in this section,
hyperlinks are provided to the command syntax of the Command Line Interface
Guide.
NOTE:
If you are setting up both ends of the network, use a mirror image of the information
listed below for configuring the router on the other end of the link.
Important: If you change any the of the following settings, you must save the change
and then either reboot the router or restart the interface for the change to take effect:
Ethernet LAN: Ethernet IP or IPX address, TCP/IP routing, IPX routing
Bridging: Bridging, filters
Remote Router: TCP/IP route addresses, IPX routes, IPX SAPs and bridging control,
and enable, disable, or add remote routers