Product specifications

Efficient Networks
®
Router family
Command Line Interface Guide
Chapter 6: Connection Management
Efficient Networks
®
Page 6-15
Dial Setting
The string for the dial setting can be either ATDT for tone dialing or ATDP for pulse
dialing. The default is tone dialing. To select pulse dialing, use this command:
-> system modem dial atdp
Disabling and Re-Enabling Dial Backup
Note: Because Dial Backup uses the console port, you must use the Web GUI
interface or a Telnet session to disable Dial Backup.
To temporarily disable Dial Backup, enter the following command:
-> system backup disable
This command stops Dial Backup. However, temporarily disabling Dial Backup does
not change the use of the console port (no console output is sent to the console port).
To re-enable Dial Backup after it has been temporarily disabled, either reboot without
a save or enter this command:
-> system backup enable
NOTE:
You can change the setting of the Dial Backup enable switch at any time, but toggling
the switch does not immediately change the use of the console port. The use of the
console port is determined only at reboot.
To disable Dial Backup across reboots and change the use of the console port, enter
the following commands:
-> system backup disable
-> save
-> reboot
Assuming that the Dial Backup remote profile is enabled, you can re-enable the Dial
Backup feature using the following commands:
-> system backup enable
-> save
-> reboot