Installation guide
2 Make the most of your Business Internet High Speed Enterprise service!
For the Business Internet High Speed Enterprise software to work reliably and efficiently, your computer
must meet or exceed the minimum requirements specified in the table below:
* If you have Windows XP, the minimum requirements are greater than those listed here. Please see the
following:
Processor: 300 MHz single CPU for Home edition, or single or dual for Professional edition
Memory: 128 MB RAM
** If you have Windows 2000 or NT, you must have the latest service pack installed.
You may need your Windows CD to perform some of the software configurations in this guide.
Check the contents of your Starter Kit
To see a list of the equipment you should have, consult
Check the contents of your Starter Kit
on page 6.
Install the software
1.
Turn on your computer. Exit all programs and disable any virus protection software.
2.
Insert the Business Internet CD into your CD ROM drive.
3.
Follow the instructions to install the software.
Install the hardware
4.
Connect the modem and install the phone filters on every phone with the same telephone number as
your Business Internet High Speed Enterprise service. Do not install filters on your modem.
5.
Check your setup. Please refer to
Checking your setup
on page 11 for an illustration of the proper
hardware setup.
Connecting and Disconnecting from the Internet
6.
Double-click the
Access Manager
icon on the desktop.
7.
Double-click the
Business Internet High Speed
icon in the Profiles window, then click
Connect
in the
Access Manager window to connect to the Business Internet High Speed Enterprise service.
If you have Windows XP, double-click the
Business Internet High Speed Enterprise
icon on the
Desktop, then click
Connect
. Then click the
Internet Explorer
icon.
Windows
Processor
133 MHz Pentium or equivalent processor
System
Windows XP*/Me/98/2000**/NT 4.0**
Memory
64 MB RAM
Hard drive
80 MB free
Display
256 colours with 800x600 resolution
Network
Ethernet card installed and functioning or available
USB port
CD-ROM drive
Required
M INIMUM HARDWARE REQUIREMENTS
Q UICK START PROCEDURES