User Guide

A NORDSON COMPANY

Section II. Configuring the Ultra TT for Bluetooth

For systems with serial number EF30188 and below:

1. Replace the board with a new Rev H board .

2. Install the configured Socket adapter.

3. Verify that the Version 1.2 firmware is installed by viewing the LCD panel display upon power-up.

4. Proceed to Section III and pair the PDA to the Ultra TT.

For systems with serial number EF30189 and above:

CAUTION

Observe proper ESD precautions when performing the following procedures.

1. Power down the Ultra TT, using the main circuit breaker on the back of the machine.

2. Unplug the power cord from the Ultra TT.

3. Remove the 11 screws that hold the electronics pan to the Ultra TT frame. There are 5

screws on the back panel and 4 along the front top edge. Two screws on the front top edge

are under the Y-axis cover plate, which is attached by two screws at the back of the cover.

Ultra TT Bluetooth

Configuration Procedure

To purchase new boards, contact EFD Customer Service (Americas: 800-556-3484; UK: 0800 585733) or your local EFD Ultra TT representative.