User`s guide

Chassis Connection
This symbol identifies the
chassis connection terminal.
Used for grounding the
chassis to shunt leakage
current and/or enhance
system EFD protection.
Power Input Port
The power input port is located at the top left corner of the Ultimus. The Ultimus power pack
automatically adjusts for 100 to 240 VAC.
Use only the universal power pack provided with the Ultimus workstation. The unit is shipped with
four power plugs (one USA and three international plugs) and a 5.9 ft (1800 mm) length power cord.
• Connect the DC plug from the cord into the Ultimus power input port.
• Connect the power cord into your local power source.
Communication Port
The Ultimus communication port, located on the top row of ports, is for EFD use only.
Input/Output 8 Pin Interface Connector
Input/output features are used when the Ultimus is interfaced with external control circuits.
The 8 pin connector is located on the top row of ports. See page 22 for details.
• An End-of-Cycle signal, in the form of an electronic switch, closes upon completion of the
dispense cycle.
Foot Pedal /
Finger Switch
Power
Input Port
Exhaust Output air Input air
Communication
Port
Input/
Output
Auxiliary
Port
Features &
Controls:
Back Panel
11
www.nordsonefd.com [e-mail] USA & Canada 800-556-3484 Europe [phone] India+ 91 80 4021 3600 Asia +China: [phone]
Sales and service of Nordson EFD dispensing systems are available worldwide.