User`s guide

2. Select Do Program and then tap “OK” to open the
Do Program screen.
3. Select the name of program to insert from
the Program drop-down menu.
4. Default for the “Do Program” instruction is at
a specific XY location. Hence, the check box
“Use XY” is selected by default. If the
program is to be placed at a Z location as
well as an XY location, check the “Use XYZ”
box.
5. Tap “Jog” and jog the dispense tip to the desired insertion point. Tap “OK” and then
“Teach”. This inserts the program at that point.
Note: The origin of the program called out is inserted at the location (either XY or XYZ) you just taught.
6. From the Edit window, select Dot or Line Parameters and enter desired values.
The higher-level program ignores the dot line parameters of the lower-level
programs. If these values are not adjusted in the higher-level program, all dot
and line parameters will run at the default settings.
46
www.nordsonefd.com [e-mail] USA & Canada 800-556-3484 Europe [phone] Asia [phone]
Sales and service of Nordson EFD dispensing systems are available worldwide.
EFD
®
TT User's Guide
Version 1.2