User`s guide

1. From the main Program window, locate the instruction line where you want to
insert a height sense command.
2. Tap “Insert”. This will open the Select Instruction window.
3. Select Height Sense, then press “OK”. The
Z-axis will go to Safe Z position or Z=0
(if there is no Safe Z specified), and
advance the probe.
4. Jog the probe to the location desired to take the height sense. This location
should be as close to the dispense location as possible. Tap “OK” and then
“Teach”. “Toggle” will allow the operator to manually toggle the height sense
probe up and down as desired.
If teaching the height sense location with the laser pointer, ensure that the box
“Teach with Laser” is checked.
5. Continue programming dots or continuous paths. Remember to assign a
dispense gap for each dot/line type. New height sense instructions can be
inserted anytime and will override the previous height sense.
6. Lastly, to get the machine to use taught Z coordinate for dispense height, you must
turn the height sense mode off by inserting a
Height Sense Mode Off instruction.
All instructions following a
Height Sense Mode Off instruction will use the taught Z
coordinate until a new Height Sense instruction is encountered.
43
www.nordsonefd.com [e-mail] USA & Canada 800-556-3484 Europe [phone] Asia [phone]
Sales and service of Nordson EFD dispensing systems are available worldwide.
EFD
®
TT User's Guide
Version 1.2