User`s guide

40
www.nordsonefd.com [e-mail] USA & Canada 800-556-3484 Europe [phone] Asia [phone]
Sales and service of Nordson EFD dispensing systems are available worldwide.
EFD
®
TT User's Guide
Version 1.2
Refer to Appendix E for detailed explanation of each line parameter.
4. When complete, tap “OK” to exit the Line Parameters screen.
5. Tap “Teach CP” to insert this instruction in the program.
6. Tap “Jog” and jog the dispense tip to the
2nd point (marked 5) of Section D. Tap ”OK”.
Select End from the Point Type drop-down
menu. Tap “Teach CP”. The CP line has now
been taught and inserted into the program.
7. Tap “Done” to return to the Program window.
8. If the toggle bracket is selected in Setup, then the “Use Toggle” box will appear in
the Continuous Path screen. Selecting the “Use Toggle” box indicates to the EFD
®
TT System that it must actuate the output to move the toggle valve down prior to
dispensing.
5.4.2 ARC
The arc command is strictly 2-dimensional i.e. Z values remain the same throughout
every single element in the arc. The Z-value at CP Start is the value used in the
(2-dimensional) arc.
To teach a stand-alone arc, three points are needed i.e. CP Start, CP Arc and CP End. The order
in which these three points are taught will determine the direction of travel during the actual
dispense. An arc point must have an anchor point before and after it and can never be followed
with another arc point. An error message will appear if this syntax is not followed.
Next, teach the arc in Figure B on the template.
Note: “1” = CP Start; “2” = CP Arc; and “5” = CP End.
1. Select “CP” from the Select Instruction window. Tap “OK”. This will open
the Continuous Path window.
2. Tap “Jog” and jog the dispense tip to the lower left point of the arc
(marked 1). Tap “OK”.
ABC = Clockwise
CBA = Counterclockwise