User`s guide

5. PROGRAMMING
5.1 CREATING A NEW PROGRAM
Before you start this exercise, print out the form called “Teaching Template” in Appendix B of this guide.
36
1. Install the tooling plate
7
on the Y-carriage and attach the printed template on it
with cellophane tape.
2. Tap “Program” in the Main screen. This will take you to the program edit
window.
3. From the Program drop-down menu, select New. This will open a dialog box to
name your new program.
4. Type in new program name. Note that program names are case-sensitive. If an
attempt is made to create a new program with the same name as the program
currently opened, an error message will be displayed.
5. Tap “OK”. This will open the Teach Program
Origin window. The program origin is the point
in the program from which all other
movements relate to, or the (0,0) coordinate of
the program.
Refer to Appendix C for a detailed explanation of
Program Origin
.
6. Tap “Jog” to open the Jog window. Use the compass rose to move the dispense
tip to the position marked “Origin” on the template.
Refer to Appendix A for detailed jogging instructions.
7. Tap “OK”. Tap “Teach” and then “OK”. This will open the program edit window.
7
EFD can supply two tooling plates: 300 X 300mm (P/N 7007-300) or 500 X 500mm (P/N 7007-500).
Alternative, user can design their own (reference System Drawings on Operation CD).
www.nordsonefd.com [e-mail] USA & Canada 800-556-3484 Europe [phone] Asia [phone]
Sales and service of Nordson EFD dispensing systems are available worldwide.
EFD
®
TT User's Guide
Version 1.2