User`s guide

steady mode
Features &
Controls:
Front Panel
10
Digital Display
• Teach button . In Teach mode, you can “teach” the deposit based
on physical size.
• Press the button once, so that the digital display flashes.
• Press and hold the foot pedal to establish your deposit size.
Tapping the foot pedal repeatedly will have a cumulative effect
on the dot size and dispense time.
• Press button again. The flashing stops. Your dispense
time is now automatically stored, with the decimal displayed
in the appropriate position.
•
Press twice to clear the display. Any decimals will disappear and
the time range will reset to 000.
• Steady button . In Steady mode, the foot pedal controls fluid flow.
• Press once and the display changes to dashes (---).
• Press again and dashes are replaced with dispense time setting.
• Steady mode is used for filling the dispense tip, dispensing
beads and stripes of material, and making by-eye deposits.
• Decimal button . Press the Decimal button to move the
decimal. When no decimal shows, the dispense time range is .000
to
.999 seconds. Note: You cannot adjust the decimal from Teach mode
(when display is blinking).
• Time Set buttons . Each button sequentially controls the display digit
in that panel. Each press advances the display from 0 to 9 and repeats.
air pressure regulator
vacuum regulator
air output
teach
pressure gauge
time set buttons
decimal button
digital display
050
50
0
.
0
0 5
.
.050 seconds
0.50 seconds
5 seconds