User Guide

5
Attach Process Feed Lines
6
Connect Exhaust Mufflers
• Insert a muffler into each exhaust port
for both cold and hot feed exhausts.
NOTE: Tubing can be purchased as an
accessory to route for remote exhaust
in lieu of mufflers.
4
Connect Thermocouple
9
Getting
Started
• Plug K-type thermocouple lead into the back panel of ProcessMate.
• Connect the other end of the lead to process hardware.
*Option: Can route thermocouple lead
with either air line tubing inside
insulation. See directions below.
NOTE: Longer Thermocouple leads may be
used when required. These are available from a
variety of sources in many lengths. Only K-Type
thermocouple leads should be used with the
ProcessMate. Using a different type will result
in incorrect temperatures.
• Slide insulation over cold process feed line.
• Slide insulation over hot process feed line.
*Option: Can route thermocouple lead with
either hot or cold process feed line.
• Insert cold process feed line into the cold
process fitting.
• Insert hot process feed line into the hot
process fitting.