User Guide

8
2
Connect Power
3
• Connect the power plug to the power pack. The unit is
shipped with a USA-compatible plug and three international
plugs. Attach the correct plug to match local power outlets.
• Connect the power cord into the back
of the ProcessMate.
• Connect the power cord into your local
power source.
NOTE: Clean, dry, filtered factory air is required to meet
the warranty. If your air supply is not filtered, order the
EFD five micron filter regulator (EFD part# 2000F755).
• Push one end of the air input hose into the
input fitting on the back of the ProcessMate.
• Connect the other end of the hose to your
plant air supply.
• Set plant air supply within 80 to 100 psi
(5.5 to 6.9 bar).
• DO NOT exceed 110 psi (7.5 bar) or
damage to the unit may occur.
1
• Use the checklist enclosed with the ProcessMate to identify all items.
If there is any discrepancy, please call us immediately.
• Now is a good time to activate your One Year Warranty. Register the
warranty online at www
.efd-inc.com/warranty/one. Or if you prefer,
follow the instructions in the enclosed “Welcome” letter
to contact your EFD representative.
Unpack the Unit / Warranty
Getting
Started
Connect Air Input