User Guide

ManualsBrandsEFD ManualsOtherPM6500

Easy 7-Step Setup

Follow these steps to get your ProcessMate

Temperature Control System ready for operation.

A NORDSON COMPANY

ProcessMate

™

6500

Temperature Control System

• Connect the power plug to the power pack. The unit

is shipped with a USA-compatible plug and three

international plugs. Attach the correct plug to match

local power outlets.

• Connect the power cord into the back of the

ProcessMate.

• Connect the power cord into your local power source.

Quick Start Guide

• Use the checklist enclosed with the ProcessMate to identify all items.

If there is any discrepancy, please call us immediately.

• Now is a good time to activate your extended One Year No-Fault Warranty.

Unpack the Unit/Warranty

Connect Power

Summary of content (4 pages)

PAGE 1
ProcessMate™ 6500 Temperature Control System ® A NORDSON COMPANY Quick Start Guide Easy 7-Step Setup Follow these steps to get your ProcessMate Temperature Control System ready for operation. Unpack the Unit/Warranty 1 • Use the checklist enclosed with the ProcessMate to identify all items. If there is any discrepancy, please call us immediately. • Now is a good time to activate your extended One Year No-Fault Warranty. Register the warranty online at www.efd-inc.
PAGE 2
Connect Air Input 3 NOTE: Clean, dry, filtered factory air is necessary to meet warranty requirements. If your air supply is not filtered, order the EFD five-micron filter regulator (EFD part# 2000F755). • Push one end of the air input hose into the input fitting on the back of the ProcessMate. • Connect the other end of the hose to your plant air supply. • Set plant air supply within 80 to 100 psi (5.5 to 6.9 bar). • DO NOT exceed 110 psi (7.5 bar) or damage to the unit may occur.
PAGE 3
Connect Exhaust Mufflers 6 • Insert a muffler into each exhaust port for both cold and hot feed exhausts. NOTE: Tubing can be purchased as an accessory to route for remote exhaust in lieu of mufflers. Operation 7 • Turn the power switch to the ON position. • Turn air switch to ADJ AIR. Turn the knob labeled with +/- markings to allow more or less air to reach the desired pressure. • Press the UP/DOWN button on the front panel display to desired dispensing temperature.
PAGE 4
Helpful Hints See User’s Guide for additional information and frequently asked questions. A NORDSON COMPANY For EFD sales and service in over 30 countries, contact EFD or go to www.efd-inc.com/contact EFD, Inc. East Providence, RI USA 800-556-3484; +1-401-434-1680 (outside the USA) info@efd-inc.com www.efd-inc.com EFD International Inc. Dunstable, Bedfordshire, UK 0800 585733 or +44 (0) 1582 666334 Ireland 00800 8272 9444 europe@efd-inc.com www.efd-inc.com EFD, Inc.