Specifications

www.nordsonefd.com [e-mail] Sales and service of Nordson EFD dispensing systems are available worldwide.
System Setup (cont’d.)
After priming the valve,
adjust lubricant flow to a rate of
approximately one drop per second.
20 System Setup
IMPORTANT: Each valve must be fully primed (lubricant flows in a steady stream)
before adjusting the spray.
Adjust the Spray
1. As a starting point, select one valve and adjust the Flow Control knob so that lubricant
flows from the valve at the rate of approximately one drop per second.
2. Note the number set on the graduated dial of the open Flow Control . Set the flow
for each remaining valve to the same setting.
3. Turn the Nozzle Air regulator clockwise until pressure reads between 0.55 to
0.69 bar (8 to 10 psi) and the valve begins to spray. Thicker lubricants may require
0.83 to 1.03 bar (12 to 15 psi). Push the knob in to lock.
4. Set the mode switch to Auto/Run . The spray will shut off. The valves are ready to
spray when the press is stamping.
5. After starting the press, adjust the Flow Control knobs as needed to provide
proper lubricant coverage.