User Guide

The Ultra Dispensing System includes pre-set specifications based on industry-standard EFD

syringe barrel dimensions. In most cases, you will want to use these pre-set specifications.

However, you have the option to adjust the settings with the Modify function.

Follow these steps to use the Modify function

1. From either the PROGRAMMED DISPENSE mode or the MANUAL mode, press the Single

Barrel Select button. The MOD (Modify) option will appear.

2. If needed, press F1 to highlight the syringe barrel size. Use the (+) or (-) buttons to select the

correct barrel size — for example, 3cc, 5cc, 10cc, or 30cc.

3. Press F4. This activates the Modify screen.

4. Press F3 to highlight the specifications for the diameter of the syringe barrel. This is

displayed in centimeters. The settings will vary according to the syringe barrel size you have

selected. Use the (+) or (-) buttons to adjust as needed.

5. Press F4 to highlight the specifications for the stroke of the syringe barrel, also listed in

centimeters. Again, the settings will vary depending on the syringe barrel size you have

selected. Use the (+) or (-) buttons to adjust as needed.

Note: The stroke should reflect the distance the EFD piston will travel to dispense

all of the fluid in the syringe barrel. For example, if the barrel is loaded half-full, a certain

stroke length (measured in centimeters) will be required to empty it. By adjusting the stroke

for a specific barrel fill level, you will ensure that the “Level” display on the Home screen

provides an accurate reading.

6. When finished, press the foot pedal once to return to the Home screen.

30cc

2.265

Dia

7.60

Strk

Barrel

select

F1/Button

Modify

Function

Modify

Function