User Guide

To deposit a continuous bead of fluid, instead of a single dot, follow these steps.
1. Select PROGRAMMED DISPENSE mode. (Press “hand” icon so red light is off.)
2. Press Forward and use (+) or (-) buttons to set Dispense Volume to lowest setting.
3. As a beginning point, keep Pause set to 0 ms and Pullback at 200 steps, then adjust as needed
to eliminate drooling.
4. For best results, set Dispense Rate to the preset of Lo, to minimize back pressure in the syringe
barrel. (Press Single Barrel Select button, then Rate, then Lo.)
5. Select MANUAL mode. (Press “hand” icon so red light is on.)
6. Press and hold the foot pedal until the required amount is dispensed. (Note: the Cycle Start
button is not active in Manual mode, so use the foot pedal to activate the dispense cycle.)
1
10cc
Shot
Steps
0.0001cc
1
Forward
Hand icon
16
How to
Make a
Bead