Technical data

Rittal Modular Safe LMS 9.3 Operation and functionality
We reserve the right to make technical changes Version 2.2
Operator Manual Page 38
Opening
Step Display
1. Push the tool into the right-hand hole until the catch opens.
2. Hold the tool in place whilst carefully lifting the cover.
3. Repeat the procedure with the left-hand hole.
/
4. Now carefully remove the cover.
/
5. Remove the bar handle and input shaft (square).
6. Replace cover (without bar handle) and snap into place.
7. Insert the key and turn clockwise as far as the stop (key cannot be removed).
If you need to change the code, proceed as follows. If a lock time has been activated, you must wait for it to
elapse before programming a new first code.
Step Display
8. Press ON.
9. Press P.
10. Press P.
11. Press 0. 1 x
12. Press ON.
13. Press P.
14. Enter the new 6-digit first code.
15. Enter the new 6-digit first code again. 1 x
In case the first code in 15) has been incorrect confirmed, the signal is given three times. Repeat the
procedure starting at step 8.
By pressing the code combination P and 0, all programmed functions (second code, double code opening
delay, ready-to-open time) will be deleted.
Closing
Step Display
1. Turn the knob counterclockwise until you can turn it no further.
/
2. Remove the key and store in a safe place.
/
3. Use the tool to remove the cover (see page 37).
/
4. Insert the input shaft through the drilled hole.
/
5. Fit the bar handle (observe the original position of the bar handle).
/
6. Fit the cover and clip all catches into place.
/
7.
Clear the alarm (only the holder of the first code (in parallel mode) or the double code (in
simple double code mode) can do this):
7a. Press ON.
7b. Press P.
7c. Enter the 6-digit first code.
7d. Press P.
7e. Press 9. 1 x