Technical data

Rittal Modular Safe LMS 9.3 Operation and functionality
We reserve the right to make technical changes Version 2.2
Operator Manual Page 30
Deleting the second code by the owner of the first code
Step Display
1. Open the lock with a valid 6-digit first code (see page 28).
2.
Press ON
.
3. Press P.
4. Enter the valid 6-digit first code.
5. Press P.
6.
Press 0
.
1 x
All functions programmed can be deleted by pressing the P and 0 keys at the same time.
(Second code, double code, opening delay, ready-to-open time)
Closing
When used in connection with a bolt lock, slide the bolt to the locked position and close the key-operated
lock after closing the door.
Step Display
1. Turn the knob counterclockwise until you can turn it no further.
Function “Delegated double code mode”
Enabling / changing the double code by the owner of the first code
Step Display
1. Open the lock with a valid 6-digit first code (see page 28).
2.
Press ON
.
3.
Press P
.
4. Enter the valid 6-digit first code.
5.
Press P
.
6.
Press 5
.
7. Enter the new 6-digit first partial code.
/2 x
8. Enter the new 6-digit first partial code again.
1x
9. Enter the new 6-digit second partial code.
/2 x
10. Enter the new 6-digit second partial code again. 1 x
11. Test the new double code just programmed by closing and opening the lock again.
In case the first or the second partial code have been incorrectly confirmed, the signal is given three
times.
Repeat the procedure starting at step 2.
The order of the partial codes and their repeated confirmation has to be observed.