Technical data

Rittal Modular Safe LMS 9.3 Operation and functionality
We reserve the right to make technical changes Version 2.2
Operator Manual Page 25
Important safety information:
NOTICE
Programming operations can only be performed when the lock and
safety door are open!!
Each key input detected by the lock and found to be correct is ac-
knowledged with an audible signal. These signals are not described in
the following section.
You have a maximum of 20 seconds to input each keystroke. If no key
is pressed within 20 seconds, the electronics switch off automatically.
Any input operations not completed must be restarted after that.
You can cancel the entry of the code by pressing the P button.
The lock is set to the factory code 123456 upon delivery. For security
reasons, immediately change this code to your own personal code. Do
not use any personal or known data as your code.
If the battery cannot be accessed from the outside, then the lock needs
to be opened using the revision key when the battery is empty or defec-
tive.
The revision key is to be stored in a secure location, but not inside the
Modular Safe.
The lock is designed for use within a temperature range of +10 °C to
+50 °C.
Clean the lock using only a moist cloth (do not use aggressive cleaning
agents).
Do not grease or lubricate the lock.
Never open the lock housing. If the armature needs to be disassem-
bled, then the disassembly must be performed according to the in-
structions in this operator manual. Otherwise you put the operation of
the lock at risk and void the warranty.
NOTICE
Please also note the information in the operating instructions for the
code combi B lock provided along with this manual.