Operation Manual

English
61
Display after the calibration movement
 After calibration has been completed, the robot
lawnmower can be used for mowing with the factory-set
mowing times without further programming.
 The mowing program is active, the battery is charged.
 The following mowing times are factory-set:
Mon - Fri: 07:00 - 10:00 and Mon - Fri: 17:00 - 19:00
WARNING!
National regulations may place limits on
the use of the machine. Comply with any
local bylaws imposing noise restrictions during
certain hours of the day.
Checking the cable laying
ca. 1 m
1. Place the robot lawnmower about 1 metre in front of the
boundary cable.
2. Press the [HOME key], the robot lawnmower moves along
the boundary cable back towards the base station.
3. In case of collisions or if the boundary cable is laid too
close, the robot lawnmower will cancel its movement.
4. Rectify the error, place the robot lawnmower about 1 m
in front of the boundary cable once again and press the
[HOME key] a second time.
Note!
Pressing the [HOME key] deactivates the mowing day.
Pressing the [START key] activates the mowing day and
starts the mowing procedure.
6.9 Starting the robot lawnmower
 Switch on the robot lawnmower by pressing the [ON/OFF
key].
Enter PIN code
 The PIN code must be entered at this point.
Display next mowing
 After the PIN code has been entered, the [Next mowing]
information appears. The robot lawnmower is now ready
for mowing.
 The robot lawnmower starts automatically when the next
mowing window is reached.
 Press the [START/PAUSE key] to start the mowing procedure
immediately.
 The [Warning drive starting] display  ashes and a signal
sounds.