Operation Manual

76
14.1 Check the rollers can move freely
1
1 Once a week, thoroughly clean the area around the rollers
(1) with a hand brush or cloth.
2 Check the rollers (1) can move and steer freely. If the rollers
(1) do not move freely, they must be freed up or renewed.
14.2 Checking/cleaning contacts
1
n Check the contact surfaces (1) on the robot lawnmower for
contamination.
n Clean the contact surfaces (1) on the robot lawnmower
with a cloth if necessary.
n Charring on the contact surfaces indicates a poor charging
contact.
n Bend the springs on the base station outwards.
14.3 Checking/cleaning the base station
1
1 Disconnect the transformer mains plug.
2 Check the contacts (1) on the base station for
contamination.
3 Clean the contacts (1) on the base station using a cloth if
necessary.
4 Push the contacts (1) towards the base station and release.
The contacts (1) must spring back into the initial position.
5 If the contacts (1) do not spring back into the initial system,
have them checked by an Authorised Service Centre, and
renewed if necessary.
14.4 Cleaning the chassis
1
2
n Thoroughly clean grass catcher (1) and guide (2) using a
hand brush or a cloth.