Operation Manual

72
1. Press the [up arrow key] brie y once. A [0]  ashes at the
 rst place in the display, or press the [arrow key] (2) once
brie y. A [9]  ashes at the  rst place in the display.
2. Either use the [down arrow key] to count down from [9] or
use the [arrow key] to count up until the required digit is
displayed.
3. Con rm with the [multifunction key right].
4. Enter the next required digits in the same way until the
date has been fully set.
5. Con rm with the [multifunction key right].
n Exit setup mode by pressing the [Menu key] twice.
10.3 Setting the language
n Before programming, it is necessary to perform the start
procedure (see page 67).
1. Use the [up arrow key] or the [down arrow key] to select
the [Setting] menu item.
2. Call up the required menu, [Language].
3. Con rm with the [multifunction key right].
Note!
The corresponding language only needs to be selected here
during the initial start-up.
1. Use the [arrow keys] to select the required language.
2. Con rm with the [multifunction key].
3. After con rming, the LCD display shows [Enter registration
PIN].
10.4 Further setting possibilities
Note!
All other setting possibilities are always called up in the
same way.
n After switching on, it is possible to call up the
corresponding program menu with the [menu key].
1. Select the [Settings] menu in the main menu.
10.5 Activate or deactivate the button tones
n Before programming, it is necessary to perform the start
procedure, see page 67 .
1. Use the [up arrow key] or the [down arrow key] to select
the [Setting] menu item.
2. Call up the required menu, [Button tones].
3. Con rm with the [multifunction key right].
4 Activate or deactivate the button tones with the
[multifunction key right].
n Exit setup mode by pressing the [Menu key] twice.