Operation Manual

English
71
10 Setting menu
n Set the time
n Set the date
n Set the language
n Changing the PIN code
n Set the button tones
n Activate or deactivate the rain sensor
n Setting the rain sensor delay
n Activate or deactivate the margin movving
n Set the display contrast
n Reset calibration
n Restore factory settings
10.1 Setting the time
Selecting the program
n Before programming, it is necessary to perform the start
procedure (see page 67 ).
1. Use the [up arrow key] or the [down arrow key] to select
the [Settings] menu item.
2. Call up the [Time] menu.
3. Con rm with the [multifunction key right].
Note!
When setting the time, it is necessary to select each
individual digit until it  ashes.
Enter the time correctly, because further programming
depends on the time.
Con rm individual digits and use the arrow keys to select
the next digit.
n The time is displayed in 24-hour format.
1. Select the required time with the [arrow keys] and con rm
with the [multifunction key right].
n Exit setup mode by pressing the [Menu key] twice.
10.2 Setting the date
Selecting the program
n Before programming, it is necessary to perform the start
procedure (see page 67).
1. Select the required program item with the [arrow keys] and
con rm with the [multifunction key right].
2. Call up the [Date] menu.
Setting the date
Note!
Enter the date correctly, because further programming
depends on the date.
When entering the year (YYYY), it is only necessary to enter
the last two digits because the  rst two 20XX are preset.
n The date display is structured as follows:
n DD for the day.
n MM for the month.
n YYYY for the year.