Operation Manual

70
Note!
n By default, the  rst entry point is always 1 m to the
right of the base station, and cannot be changed.
n By default, another 9 entry points are distributed along
the overall length of the boundary cable (after the 1st
edge mowing or complete loop movement).
n These entry points can be changed and programmed
according to the size and composition of the mowing
area.
1. Use the [up arrow key] or the [down arrow key] to select
the [Point X*] menu item until the star symbol appears to
the left of the menu item.
2. Set the required distances and set additional entry points if
necessary.
3. Con rm with the [multifunction key right].
n Press the [menu key] again to return to the main menu.
Teaching-in start points
n Press the [START/PAUSE key] to start the procedure.
n Follow the instructions on the display. [Teach-in start
point]
n Set start point X.
n Position: Set Y m with the [multifunction key right].
Note!
n No start point is set.
n The loop length is measured and the start points are
automatically distributed evenly over the length.
n The start points can be adapted manually.
n (5) End time
n The robot lawnmower moves back to the base station at
the selected time.
n (6) [0 - 9] Fixed entry point
n The robot lawnmower departs from the selected entry
point at the selected time for mowing. These entry
points can be set.
[?] Automatic entry point
n The entry points are changed automatically
(recommended setting).
9.2 Setting entry points
1. Use the [up arrow key] or the [down arrow key] to select
the [Programs] menu item until the star symbol appears to
the left of the menu item.
2. Con rm with the [multifunction key right].
Calling up entry points
1. Use the [up arrow key] or the [down arrow key] to select
the [Entry points] menu item until the star symbol appears
to the left of the menu item.
2. Con rm with the [multifunction key right].