Operation Manual

English
55
5 Assembly/installation
5.1 Assembling the base station
3
4
1
2
2
1
n Insert the base plate (3) with its front edge in the direction of arrow 1 into the plate of the base station (2), and fold upwards in
the direction of arrow 2. Place the extension plate (4) under the base station (2) and secure it with lawn pegs (1).
5.2 Setting up the base station
min. 1 m
min. 20 cm
min. 35 cm
min. 1 m
1
2
n Place the base station in a shady location in the garden on smooth level ground where it will be protected against the rain.
Then use lawn pegs to secure it in place (white dots). Comply with the speci ed dimensions when doing this.
n Remove the insulation from the boundary cable (2) and connect it to one side (1) of the base station. Then continue to lay
the cable as shown, complying with the speci ed distances.
n To avoid damage when mowing, make sure that the boundary cable (2) is in direct contact with the ground at all points
when you are laying it. If there are places where the boundary cable (2) is not in direct contact with the ground, secure
these with an additional lawn peg.