Operation Manual

31EN
PROBLEM LIKELY CAUSE SOLUTION
5. Starting is
dicult or the
engine runs
erratically
– fault in carburation – clean or replace the air lter
– empty the fuel tank and rell with
fresh fuel
– check and replace the fuel lter
if necessary
6. Poor engine
performance during
cutting
– forward speed too high compared
to cutting height
– reduce the forward speed and/or
raise the cutting deck (
5.4.5)
7. The motor shuts
down whilst working
The safety device of the electronic
circuit board has cut in due to:
– the safety devices have cut in
Turn the key to «STOP» and look for
the cause of the problem:
– check that the conditions allowing
starting are met (
5.2.b)
8.
The blades do
not engage or do not
stop promptly when
they are disengaged
– problems with engagement
mechanism
– contact Your Dealer
9. Uneven cut
and poor grass
collection
– cutting deck not parallel to the
ground
– blade cuts badly
– forward speed too high compared
to the height of the grass
– forward speed too high compared
to the height of the grass
– collector channel is blocked
– check the tyre pressure (
5.3.2)
– realign the cutting deck ( 6.3.1)
– contact Your Dealer
– reduce forward speed and/or raise
the cutting deck (
5.4.5)
– wait for the grass to dry
– remove the grass-catcher and
empty the collector channel
(
5.4.7)