Operation Manual

16EN
5.3 DIRECTIONS BEFORE STARTING
WORK
Before starting to mow, it is necessary to
carry out several checks and operations
to ensure you can work eciently and in
maximum safety.
5.3.1 Seat adjustment
To change the
seat position,
loosen the four
xing bolts
(1) and slide
it along the
slots.
Once you
have found the
right position,
tighten the four
screws (1).
5.3.2 Tyre pressure
Having the right tyre pressure is the main
condition for ensuring that the cutting
deck is horizontal
and mows evenly.
Unscrew the valve
caps and connect a
compressed air line
with a gauge to the
valves and adjust
the pressure to the indicated values.
5.3.3 Filling with oil and fuel
NOTE
The engine manual indicates
what type of oil and fuel you can use.
With the engine o, check the oil level.
According to the instructions in the engine
manual, this must be between the MIN
and MAX marks on the dipstick.
Refuel using
a funnel,
but do not
completely
ll the tank.
The tank’s capacity is about 6 liters or 4.5
liters.
DANGER!
Refuelling should be
carried out in an open or well-
ventilated area with the engine o.
Always remember that petrol fumes
are inammable. DO NOT USE A
NAKED FLAME TO LOOK INSIDE
THE TANK AND DO NOT SMOKE
WHEN REFUELLING.
IMPORTANT
o not drip petrol onto the
plastic parts to avoid damaging them.
In the event of accidental spills or leaks,
1 1
1,0 bar
1,2 bar
(15 x 5,00-6)
1,5 bar
(13 x 5,00-6)
1,0 bar
1,2 bar
(15 x 5,00-6)
1,5 bar
(13 x 5,00-6)
MAX
MIN