Operation Manual

9EN
For storage and transport purposes,
some components of the machine are
not installed in the factory and have to be
assembled after unpacking. Follow the
instructions below.
IMPORTANT
The machine is
supplied without engine oil or fuel.
Before starting the engine, ll with oil
and fuel following the instructions given
in the engine manual.
WARNING!
Unpacking and
completing the assembly should be
done on a at and stable surface,
with enough space for machine
handling and its packaging, always
making use of suitable equipment.
3.1 UNPACKING
When unpacking the machine, take care
to gather all individual parts and ttings,
and do not damage the cutting deck when
taking the machine o the pallet.
The packaging contains:
– the machine;
– the steering wheel;
– the seat;
– the front bumper (if provided);
– the battery;
– the grass-catcher (with instructions);
– an envelope containing:
– the instruction manuals and
documents,
– nuts and bolts including a pin for
locking the steering wheel,
– starter keys and a spare 10A fuse.
NOTE
To prevent damage to the
cutting deck, raise it to its maximum
height and take utmost care when
taking the machine o the pallet.
Hydrostatic transmission
To make it easier to move or take the
machine o the pallet, put the
transmission disengagement lever in
position «B» (
4.33).
Disposal of the packaging should be done
in accordance with the local regulations
in force.
3.2 FITTING THE STEERING WHEEL
Put the machine on a at surface and
straighten up the front wheels.
Fit the steering wheel (1) onto the
protruding shaft (2) with the spokes
directed towards the seat.
Line up the hole on the steering wheel
hub with the hole on the shaft and insert
the pin (3) using a hammer.
Make sure the end comes right through to
the opposite side.
NOTE
To avoid damage to the steering
wheel, use a punch or a screw-driver
of the same size as the pin when
hammering it through the hole.
3. UNPACKING AND ASSEMBLY
1
3
2