Operation Manual

18EN
4.31 BRAKE PEDAL
This pedal works the brake on the rear wheels.
4.32 DRIVE ENGAGEMENT PEDAL
This pedal engages drive in the wheels as well as modulating
the machine's forward and reverse speeds.
– To engage forward
drive just press it in
the «F» direction with
your toe-cap, noting
that increasing the
pressure on the pedal
progressively increas-
es the speed of the
machine.
– Reverse is engaged
by pressing the pedal
with the heel, in the
«R» direction.
– The pedal automati-
cally goes into neutral
«N» when released.
– The “neutral” condition
«N» is shown by the
lighting of a pilot lamp
(4.10.e).
Reverse must only be engaged when
the machine is stopped.
If the drive pedal is used, whether for-
wards or for reverse, when the parking brake (4.5) is
engaged, the engine stops.
4.33 LEVER TO RELEASE THE HYDROSTATIC
TRANSMISSION
This lever has two positions as shown on the label:
«A» = Transmission engaged: for all usage conditions,
when moving and during cutting;
«B» = Transmission released: considerably reduces the
effort required for moving the machine by hand, with
the engine turned off.
To avoid damaging the transmission unit,
this operation must be carried out only when the engine has
stopped with the pedal (4.32) at position «N».
WARNING!
NOTE
IMPORTANT
A
B
4.31
4.33
N
4.32
F
R