Installation & Assembly

Installation
2/2020
Page 4 of 4
Stairs
Use single or double undercut stair nosing and cut modules. Since Kinetex will be flat to both the tread and riser, Kinetex Modular Adhesive or
our SRT double-sided foam tape (SRT is sold in roll sizes of 3” x 166’ – 41.5 square feet coverage) is required. When using full spread Kinetex Adhesive,
install modules on steps and risers, inserting the stair nosing edge and the top of the riser edge of each module into the vinyl undercut. For
installation of Kinetex Modular on steps, nosing is required. The nosing manufacturer’s adhesive, SRT tape or contact adhesive is required to
secure the nosing material. The riser material should receive an application of Kinetex Adhesive on both the riser and the backside of the
module in order to achieve a secure bond.
Cutting/Trimming
Kinetex modules may require cutting at perimeters, floor electrical outlets and door openings. Perimeter modules may be cut in the
conventional way of letting them cover up the wall areas when cutting them down with a tool such as a cushion back wall trimmer; or they
may be cut by measurement, cutting from the back using a carpenter’s right angle square and a wall trimmer tool. Whenever modules are cut
or trimmed, adhesive must be used. Small pieces of Kinetex modules should also have glue applied to the backing to help hold them in place.
Completing the Installation
To avoid dislodging modules, do not walk on or move furniture onto modules until the area is completely anchored. Roll entire area with a 75-
100 lb. roller in both directions (north-south and east-west). It is also required that sheets of plywood or hardboard be laid over the new modular
surface when transporting heavy furniture on carts or dollies. As a final step, vacuum the entire area with an upright vacuum.
NOTE: These installation recommendations are made for the experienced installer. Adherence to these procedures will result in a
quality installation. Any questions concerning these recommendations or any special situation encountered should be directed to
the EF Contract Customer Relations Department.
Chair Pads/Mats
The use of chair pads/mats with spikes will void all warranties.
Following the Installation
Please refer to the Kinetex Adhesive instructions for more specific and complete details. However, please note the following requirements:
1. The new installation of Kinetex flooring is not to be cleaned for 48 hours utilizing any wet or chemical cleaning process.
2. The indoor temperature should never fall below 55º F, regardless of the age of the installation.
3. Chair glides and casters for use with Kinetex must be of a type specified / suitable for carpet or soft surface (narrow tip chair supports or
90 degree edges are not suitable). The correctly specified glide or caster will protect your investment from damage that may otherwise not
be covered by the floor manufacturer’s warranty.
4. Plastic Film Protection often includes adhesive. This type of protection is not recommended, as its adhesive can transfer to the Kinetex face
causing aggressive soiling of the product. Instead, Kraft paper, hardboard or similar protection is recommended.
For additional inf
ormation, please
call
800.451.1250 ext. 8020 or visit efcontractflooring.com.