Specifications
Commercialon
®
Premium Adhesive for Modular Carpet and LVT
efcontractooring.com
Concrete Moisture Testing
and pH Testing
Substrate surfaces must be tested for moisture. It is the
responsibility of the owner or owner’s representative to
perform moisture testing prior to starting the installation.
ASTM F 2170-2 relative humidity probe moisture testing
is required. Acceptable relative humidity probe testing
results are up to 90% RH. Alkalinity tests should also be
performed per ASTM F 710. The maximum acceptable
pH is 9.0. For test results that determine RH test readings
above 90% RH or pH readings of 9.0 – 11.00, XL Brands
DriSeal 95 Penetrating Concrete Sealer is required.
Application
Note: Read all installation instructions thoroughly before installation.
1. Spread adhesive over a solid surface only. Soft adhesives
or any surface that does not support the adhesive will
result in a failure of the product. Do not spread more
adhesive than can be covered within 2 hours. Roll
modular carpet and LVT with a 100-lb. (45,4-kg) roller
when complete.
2. For modular applications, apply with a 3/8” (10-mm)
nap or foam paint roller at 120 sq. yds. Per 4 U.S. gals. (100
m2 per 15,1 L). Allow adhesive to dry clear before laying
modular carpet.
3. For LVT applications, apply with a 1/16” (1,5-mm)
square-notch trowel. Begin installing tile after the trowel
valleys become clear (about 20 to 30 minutes).
Clean Up
Wet adhesive may be removed with warm soapy water.
Dampen white cotton toweling and blot to remove (do
not rub). Dried adhesive may be removed using the same
dampen and blot technique with safety solvent.
Warranty
For complete EF Contract warranty information contact EF
Contract at 800.451.1250 or visit efcontractooring.com.
Shelf Life
Two years from date of manufacture in unopened container.
Freeze thaw stable to 10°F.
For more information, technical or installation
questions contact:
EF Contract
1502 Coronet Drive
Dalton, Georgia 30720
800.451.1250
Product Performance Properties at 73°F (23°C) and 50% relative humidity
Laboratory Tests Results
Polymer type Acrylic
Drying time About 2 hours
VOCs <50 g per L
Consistency Paste
Color Blue
Temperature range for application 50°F to 90°F (10° to 32°)
11/2018