User's Guide

11
WEARING THE DEVICE
Battery
Your SonX device is shipped with a battery. Depending on the amount of communication requirements, your
amulet should work up to 20-30 hours when fully charged.
To install the battery, turn the back of the amulet towards you and holding it by the sides, with the battery
label facing downwards, glide the battery male component into the female USB slot in the amulet.
To remove the battery, hold the sides of the amulet and grab the end of the battery. Pull until it slides out.
NOTE: Your battery is shipped with a charge but may not be fully charged. Be sure to plug into your individual
or master charger before your next use.
Charging the Device
To charge your amulet, remove the battery from the amulet and connect to the individual wall charger or 10-
port hub charger provided to your supervisor. When plugged in, a LED light will turn on “orange” for charging,
and then “red” to indicate the battery is fully charged and ready to use.
TIP:
1. To preserve battery life, turn your device o during breaks or when not in use.
2. The battery can be charged at any time, regardless of depletion.
3. Avoid overheating your battery and reducing its lifetime use: once fully charged remove the battery from
the charger.
ORANGE Battery charging
RED Battery fully charged